top of page


 This is a 3D printed joystick handle for electric wheelchairs. We call this shape the Grip handle. The surface texture was made rough on purpose to provide a better grip. The handle is approximately 4.5" (115mm) wide, 1.8" (43mm) tall, and 0.8" (20mm) front to back. Included in the purchase are one Curve handle and one allen wrench for the set screw.

 The handle is intended to replace a missing knob, or perhaps is better suited for the user. This handle was created to fill a need. Some people lack the dexterity to control their chair in its stock setup and may find this shape allows better control. Most chairs come with either a 3/16" or 1/4" diameter joystick shaft. You'll need to verify which one you have before ordering.


The knob you receive will include a small allen wrench. Use the wrench to "lightly" tighten the two set screws (across from each other) near the base of the handle (overtightening will strip the threads). The set screws won't completely prevent the knob from turning but should prevent accidentally knocking it off.


    Contact us with any questions or concerns

Product Page: Stores_Product_Widget
bottom of page